Recent content by bbbblaah

Hey all, I believe my amp is busted and I was wondering if there are any amp repair shops around North Carolina that I could take it to. If not, can anyone recommend a good person to send it to. Thanks

Cool, so from the box the whole assy. measures 18" from the end of each flare or the total length. So I should just cut off 1" from the straight tube correct?

Ok so I ordered the psp 4" flared ports. Is the 17" that is required the length from the ends of each flare, or the length of the tube before the flares? I am assuming to the end of each flare.

Thanks, so psp-inc gives me a straight length req of 17.32" for 3 4" aeros. If my box is only 20" tall, will this gap be too small. If so, what should I do?

Cool thats how it is right now, I will def. do 3 4" I was just worried that it would not be enough port area. But I will do that, esp. since I was at the store and saw how much 90deg. bends cost. Is there a minimum space between the end of the port and the box wall that I need to maintain?

Any other input, I like 2 6" aeros the best for port area purposes, but I do not know how to fit them in because they need to be around 24" long or something close to that. Should I buy some 90 degree bends and fit the rest in by bending it and having it go at the bottom of the box?

It's in an extended cab truck. Wedge style box port firing up. Box is 20" tall outside. So if I go with 2 6" then I would probably have to bend it correct? Or is there a better option?

Hey all, I am currently using a slot port and want to change to aero ports. My box is roughly 5.25 cu without port displacement and I would like to tune around 32-34 hz. I am running 2 type r 12s. So what size and how many ports should I use? I was thinking at least 2 and maybe 5" Suggestions?

Thanks, fuse size?

Ideas anyone?

Hello, I am installing a new setup and this is my first full install alone. I am running 2 12" type-r 4ohm dvc subs in parallel with a hifonics 1210d amp to 1ohm. Ported box about 4.5 cu @ 35hz. Going in a extended cab pickup. I am wondering what all and how many wires I need to buy to fully...

I've been searching to find this but I can't figure it out. When calculating vent length, what do you use for Vb in the formula? The displacement with or without port displacement? If with, how do you know what to use for port displacement if you don't know the length? Or do you use the...

Are you saying to not use the RE Calculator? Why are the side L-Ports not good? I am not completely sure how to calculate the port volume/tuning for my box with a middle port. The face of the box is angled. The dimensions for the box are 52" wide 20" high, top depth is 10" and bottom depth is...

So I did some measuring and it turns out that I only have 12" depth at the top so I dont think I will be able to mount the subs up. The port and subs will have to face forward. So I have started playing around on the RE L-port enclosure calculator and it is looking good. I can get about 4.5...

Where is this at? I don't know any good sites for audio equip