Recent content by BAT284

i doubt there is any authorized shop nearby. i do plan on doing a lot of research on active tuning and getting help from someone nearby. I have read that the with DSP6 the input voltage does get split to the output voltage. I would like to know if the same gets done with the bit one. if so is a...

Question on the Bit One: Can the Bit One accept 2 channels of preamp signal and output that signal to 6 channels (3 sets at different crossover settings)? If yes, then if my input voltage is 5 volts each, will that voltage be split to the 6 outputs or will each output voltage be 5 volts or...

Thanks, that set looks awesome. I am guessing I will have to run active for this component set, correct? If so, any recommendations on crossovers. I still would like to install the kenwood 9140 HU.

What's the take on Eclipse's flagship (AVN726E)?

Currently putting together a build. Car: '09 Jetta HU: Kenwood 9140 Front: that is the question for this post Rear: factory has 6.5 or 5.25 components installed. will replace those for either a component set or coaxials. whichever is better for my needs and SQ Sub: don't know yet. opinions...

Anything constructive??

Here is the issue: My front door has a factory 3-way speaker system installed. I have done some research and found what should fit in the doors with little modification. Each door can fit: 1 - tweet 1 - 3.5" to 4" speaker 1 - 8" midbass or woofer I'm thinking I have two good options...