Recent content by basscube5

Lol. Nice setup you have there. I already have a bnib circa 2000 ZR 1000 and a ZR240+ZX460 I bought pretty recently. It'd be kinda ****** to split up what you have there but I don't need more amps lol. Just the same, PM me a price and maybe?? Oh yeah, and what's the little guy? ZR120?

Guys! I need two end caps and an amp link. I have a ZR240 and a ZX460. I'm willing to pay good money as well, not looking for a handout. Let me know what you have. mccann.nathan@gmail.com Thanks!

I agree 100%, the current numbers aren't right. You can't fake a sine wave though, I'm satisfied enough to proceed installing it at least. It's only running 2 XFL 10s @ 1ohm, if it can do close to 2K rms I'm hoping it'll be lots.

Just a clamp meter, it reads AC or DC current. I was expecting more current too. It was pulling 13A @14V from the battery and putting 48V @ 3A to the woofer, which I think are junk numbers either because the power supply wasn't stiff enough or the woofer was wayyy high impedance wise. This...

I did measure current in the leads going to the woofer, but it was really low. Maybe it was my meter but most likely it's because the sub was in free air and the impedance went through the roof. Just the same I was powering the amp off a 20' set of booster cables with the last 12" from the...

Figured I'd post another reply. I was a bit quick to slander AB earlier, I did some more testing and based on what I found 2-2500 seems possible. I have a Hantek pc based oscilloscope, gotta love the chinese and their instructions. Anyway, the Hantek works real well but it turns out if you...

just for kicks I'm going to take another swipe at it here in a bit. I'll try a 50hz tone this time too. I'm going to yank the cover off and measure the rail voltage as well. But yeah, I'm with you Jeff, if this is the case this POS isn't even going in my car. I'll report back.

Hey Guys! I bought a VFL 4480 recently to run two XFL 10s. I'm not in a position right now to start building a box and installing everything but my curiosities got the best of me today so I did a little test. I hooked up the 4480 temporarily and ran a clean 40hz test tone through it to see...