Recent content by bando81

Ok thanks

Here’s my setup to help with some of my questions. My amp is 5 channel rated at 60W x 4 + 400W at 4 ohms. My speakers are diamond 652 the website says they’re at 50W RMS and don’t list the impedance but another site says 4ohms The sub is RF p3 12” d2 dual voice coil at 2ohms. The specs say...

Would I easily be able to if they’re damaged

I was starting to do this but the 1000hz tone was getting really loud

Perfect. Thank you. Just curious. What happens if positive and negative touch

The LC7i has 8.5 volts output and my amp has 5v input sensitivity. So I assume that means that if the LC7i is turned to the max on the output controls, it’s going to be putting out too much voltage that my amp can handle, correct? I feel like the goal is to match the voltage output from the LOC...

I watched this. I don’t know to use my multimeter the way he does. He rigged RCA cables to his multimeter probes to measure the output from the LOC. I can’t seem to figure out how to do that without the little contraption he made. If you could spell out how to measure the voltage coming out of...

I have an Lc7i running the front speakers on the main channel, rear on the 2nd channel, and then no speaker inputs for the 3rd channel but I do have a sub running from the channel 3 output. This all ends up at a kenwood xr901-5 powering 4 coaxial speakers and a 12” sub. I know for a fact the...

theres 3 pairs of RCA running from the LC7i. The main outputs, the channel 2 outputs, and the channel 3 outputs each have a pair of RCA running to the Line In RCA on the Amp

I have a ‘13 volt. The factory head unit runs to the LC7i, which then runs to the 5 channel amp. Is there a way to add an EQ to this setup? I have a Massive Audio EQ7X