Recent content by Bagged04

I will try that tomorrow and post the results. Thanks

I'm not exactly sure what u mean by phase, but if you go here http://www.the12volt.com/caraudio/woofer_configurationsm.asp?Q=2&I=22#results There wired exactly as shown for a 2 ohm load. Yes I actually did research all this and called companies directly. The only thing I did do apparently...

Yes the subs are dual 2 ohm, wired to 2 ohms in the box. I did check with a dmm when I originally put the box together. I figured I'd need a bigger alternator. What I'm confused about is why when I wired 1 sub to 1 ohm and put it on a kicker 1200 it hit. Now that I have both subs re wired to 2...

well i appreciate the input from everyone but seams i need to get some sleep.

ha, just kidding. My brains exhausted, I checked my receipts there the dual 2 ohm subs so after looking at the diagram i used its at a 2ohm load not a 1 ohm load. i knew it didnt seam right about 3000 rms. I got that amp to pair with those subs perfectly after speaking with sundown rep. now that...

Doesn't the capacitor stabilize the voltage as far as pulling powerfrom it instead of just pulling straight from the battery? I don't drive it every day its a weekend toy. But I figured I'd kill the stock alternator with it. I was looking at a 300 amp alternator and yes its a bagged 04...

right now stock alternator, with big 3 upgrade done, an optima yellow top and a soundstream 20 farad cap to help stabilize voltage. i hope it does till i can afford a bigger alternator. and all wiring done with knukoncepts oversized wire 1/0 gauge.

yes its set to master not slave. its new too, kenwood dnn991hd.

so far iv just been kinda playing around with the gain, subsonic, low pass, bass boost, etc. just trying to get a decent sound to come out but havent had any luck.

My bad. It is 1ohm they're wired to checked with a dmm . Got the diagram at the12v.com. but yes 1.5 cuft per chamber. So 3 total cuft in the box.

heres a picture of the subs in the box.

And it keeps giving me an error message trying to upload photos

What makes no sence to me is I got a bad amp at first, the same scv 3000d and had to put a friend's kicker 1200d to 1 sub wired at 1ohm and it hit. But now tht my amp came in it just dnt hit at all barely anything out of either sub.

My bad. It is 1ohm they're wired to checked with a dmm . Got the diagram at the12v.com. but yes 1.5 cuft per chamber. So 3 total cuft in the box.

2 sa12's d4s hooked up to a scv-3000d not hitting. Subs wired to 2 ohms in a ported box with 1.5 cuft air space. Biggest ported box I could get while retaining my back seat.