Recent content by aurorakid

Nah ended up selling the unit and going with a AVN2210P which I like much more.

It must be the amps. With nothing hooked up except power the one is still in protect. Hooked my old amp back up and I'm bumpin again with 2 volt drops at idle.. This amp should be putting roughly the same amount of power as the Strike yet is twice as loud as well. Amps were junk!

spelling ftl

Go with what you liked better. A better sub is what pleases you. I'd take the CVR over that though.

I have not tried that but I will.

Well I went out in the night and rain and checked it out some more. Undid both subs and checked fuses. Fuses are unblown. With ZERO speakers hooked up the amp still goes into protect...

Yeah that is it on amp guts. My volts never dropped below 14.7. I don't know with the car off. My AB amp would have been pulling **** near twice the current and I ran the battery down dead 3 times with it and it never messed up. Literally dead and it never low volted or anything. I ran the...

I haven't got a clue. All I know he is a bought A LOT of these from someplace. Resold ALL as refurb and needing power connectors. He said he put power connectors on mine for me. I could take it to the local community college have them take a look but I'm sure that guy has had enough with me...

I have not. I just went straight with a paypal dispute. Should I just ohm my wires with the dmm before I hook my old amp back up? Edit: My old amp I was using is a Tidus Titanium TM400.4. I was running each sub at 4 ohms bridging the 4 channels down 2 and getting max power of it. It it a surf...

Well I guess I can kiss my dream of running a PG TI12D Elite at 2k away. I might as well not even buy the sub now. I'm back to running junk cvrs on a 800 watt rms amp made for tweets and mids lol. I'm sick of this every time I try to get something going good I get ripped off.

Nope. Voice Coils are in series and subs in parallel. Final load of 2 ohm. They have been securely wired for like for just over a year for my class ab amp. Kicker CVR's wouldn't take it at .5 ohms either. Edit: Setup is in my sig. Subs are dual 2 ohm cvr's.

I had the other wired up and it was playing for about 5 seconds until I went to turn my car on. It didn't come back on with my car. Blew all fuses. Replaced fuses. It went up in smoke. I wired the other up. Played this one with the car on. Shut it off and after 5 seconds this one quits playing...

Such as? I'm a not a noob. I've been into car audio for while. I know what I'm doing and never had a problem like this ever. Not likely. It was hooked up to my AB amp and ran just fine before I tried these. I will try my old amp again tomorrow and see how it goes.

What do you mean by amp swap? I tried one it blew in 10 seconds. The other lasted a half hour. I'm thinking the other buyers gave feedback when they recieved the item or just tested to see if they powered on. They did indeed power on and play for a little while. One very short while.

I know Lighting Audio isn't the best but I seen a few on here running the amp so I thought maybe it was a good model by them. The funny thing is he got 100% feedback for every amp he sold. The thing about getting my money back is I will have to ship the junk back. I guess it's back to my class...