Recent content by ANGEGALVAN1

Okay update installed some cca oversized 0 gauge from skyhigh and my amp was clipping at a 2 ohm load.

Cause someone said that the headunit causes clipping as well

Or up the gain on the amp ? Its half way on the amp

I got a video here Looks like it was blinking red. And yeah im going to check the voltage to see what its at full tilt.

It doesent happen specifically before full volume. It just depends on the song if its bass heavy or not. The sub was pounding hard but then I heard clipping and looked at the amp clipping led light. I'm not sure about voltage on that. But I am running a pioneer 4100nex so its not a cheap headunit

Absolutely but does the 4 guage wire have anything to do with it? I heard these amps pull a lot of amperage.

So i have stock electrical with a 4 guage wire on a hd3k and i have the gains set at half @1 ohm on a skar ddx 10 inch. Before I get roasted I'm planning on going to 0 gauge asap haha. So I had my headunit like 2 notches before full volume and I was playing some decaf 30 hz 35 hz. And I had...

Okay thanks ! it hits good at 35hz

So my box is currently like at 1.9 or 2. I put in a 4 inch port that is about 9 inches long. She sounds really nice for a 10 but i feel like she has a higher potential. I want to stick in a 5 inch port or a 6 inch port. I just want it to tune it at 35hz or around there. I have it hooked up to a...

Sorry got to excited with the build, so i put in a 4 inch diameter and about 9 inch long port and she loves the 35hz, I feel like the port is too small so might bump it up to 5 inch

Hello im planning on hooking a Skar DDX 10 inch with about 1.7 to 1.8 cubic subwoofer box. I plan on making a box underneath the rear seats on a f150 but im going to lift the seat a couple of inches. My question is ive never understanded how big or long port holes should be for a box. I've used...