Recent content by andycc529

  1. A

    help wiring my components?

    where do you usually put the crossover? Also, I'm assuming the amp goes in the trunk, so you would then have to run wire from the deck to the amp in the trunk, and then from the amp to the cross over?
  2. A

    help wiring my components?

    that sounds simple enough haha where should I mount the tweeter?
  3. A

    help wiring my components?

    I just bought precision power 356 cs components for my front and and an alpine amp for them. Can anybody offer me wiring help? I've wired regular speakers, but have not wired components or amped speakers. I'm guessing I am going to need a bunch of 12 gauge wire for starters?
  4. A

    what are good 6.5" speakers to get?

    in doing this setup, I wouldn't need rear speakers?
  5. A

    what are good 6.5" speakers to get?

    No, I'm not on acurazine.com What is that? I am running them off an alpine deck, I can't remember which model.
  6. A

    what kind of amp to get?

    My budget is between ~ 400-500
  7. A

    what are good 6.5" speakers to get?

    I listen to hip hop primarily. My budget for 4 speakers is between 100-200. I don't know how much I would be spending on an amp. I have an Acura tl that originally thad a bose system. I had to rewire the system to bypass the stock pre-amp when I was installing my previous speakers. I have...
  8. A

    what kind of amp to get?

    thanks, i will look into an amp of those specs. any suggestion on a brand?
  9. A

    what are good 6.5" speakers to get?

    What would be a good set of components in the front? Also, is it difficult to mount the tweeter somewhere in the car? What does a crossover do? Thx
  10. A

    what are good 6.5" speakers to get?

    If I were to amp my fronts, does anyone have any speakers they could recomment (not sell)? Should I get 2-way, 3-way? Should I consider getting components? Thanks
  11. A

    what kind of amp to get?

    I am looking into 2 10" resonant engineering subs 4ohm dvc. They are listed at 600 rms ea. What type of amp should I be looking for that will sufficiently power these subs? (Like how many watts, how many channels etc? I have very limited knowledge of amps and wiring) thx
  12. A

    help pleasE?

    so if i'm getting 2 dvc subs at 4ohms that are 400 rms, what kind of amp should I be looking for?
  13. A

    help pleasE?

    any suggestions on what I should look for in buying an amp and subs that go along with it? I guess I am looking for 2 subs around 400 rms each and a good amp to power them.
  14. A

    help pleasE?

    Can someone breakdown the difference between 4-ohm and 2-ohm?
  15. A

    subs not working..

    My subs, which had been working for several years, just stopped working a few months back. I have been unable to figure out why. I checked all the wires (from the h/u to the amp to the subs) and everything seems fine. All the fuses are good too. In those few months, every now and then the...
Top