Recent content by Always@8K

ok thats it. im porting two IDQ10V3.D2's. im thinking the precision power 1000.1 amp - or whatever i can get for my trade in at a local stereo store. i will update.

been doing some research on this and that. it would be hard for them to design my enclosure without the truck being around. the calculations i just worked out actually led me to around 2.1-2.3cf3 on the airspace. i could port it with a 3" aero port by about 19" long. this opens my horizon a...

thanks a lot guys for your insight so far. im just getting off nightshift at work- time for bed. i will be on later to check up. this is awesome.

i edited the post. accounting for the mdf it will only be 20" long yes. the baskets will practically be touching eachother, but they will fit.

accounting for 3/4" mdf.. it will be 21.5" long' date=' 10" wide, and 19.25" tall (accounts for 2" downfire space). where the speakers mount, it will be 11.5" wide. i am accounting for airspace measurements for the 10" part. for basket mounting measurements it will be 10".   ---------- Post...

hmm.. so i need to have the port firing forwards? no doubt about it?

like this? the port would have to fire to the rear, which it would fire directly into the rear wall. it wouldnt work. if i forced the port out the front, i would have recess the the angle of the front of the box...which i could do. it would be a major pain in the *** though. Or i could have it...

One as in what? the amp? I was hoping to run two 10"s. That amp is rated at 1200w rms at 1ohm - not sure how good it is. Guys - i have been out of the audio stuff for years. Im like a noob all over again. My amp/sub combo right now is about 3 years old. I was heavy back into this stuff in like...

hmm its only single voice coil? its fairly cheap sub too? seems like dayton does home audio stuff. would something like a Hifonics Brutus BRZ1200 work on it? i just dont know about the whole port issue. Its going to be hard to fit it into the box because of the design?

Hmm.. ok i will look into those. It just seems kind of nuts to have 2 10"s ported in such a small enclosure. I have no idea where i would put the port?

Im pretty set on downfiring due to the speakers being protected, sound quaility, and cleanliness. I appreciate the help though! Ok. I really like the image dynamics line. I have ran a Diamond M6 15" before and was just completely thrown off guard by its abilities - thats why i wanted another...

Ive tried searching the forum for a few but nothing was too specific to my situation. I am hoping someone can throw some guidance my way. I have a 2012 Access cab Tacoma. I am running a single 12" audiopipe txx-be12 with a jackhammer monoblock amp (its rated at 600w rms but i think its pushing...

Mic:Classic TL Box:27hz Electrical System: Stock 130amp Alt, Stock Battery + Optima Red Top Amplifier(s):1 Harrison Labs 1600w 1ohm Subwoofer(s):1 Diamond M6 K2 15" wired at 1ohm Vehicle:95 Mercury Mystique Song/Tone Played: Lil Jon - Throw it Up Test Results: 146.9db