Recent content by All_Logix

If you want, and the speaker comes off of the space, you can use the space as a template to make a new one out of MDF. Then you can coat the MDF to waterproof it and it wont rattle as much

Make sure you get a respected alt brand as well. Getting cheap Ebay knockoffs will end badly for you

For 100 Shipped I am interested but you inbox is full

To answer your question, you really need to use a meter and test the potential difference between the battery neg post and the area you are trying to ground to.

Considering that most amps use a basic POT for the LPF setting, this is your best bet. Honestly the only true way to test that is to have a tone generator and measure the output for the different frequency bands. Also something to consider, I am sure there is a slop to that xover, most likely a...

Your going to have to help me a little more here bud, I read your link and don't see what you mean. I am pretty familiar with OHMs law but I just don't know this part.

Can you elaborate on this, I am not familiar with this law.

If you are wanting to actually achieve these power outputs, it will not be possible with just a wire upgrade and capacitor will not get it. You have to start at the source of the power and that would be your alternator. I would go ahead and change out your alt, get a decent AMG battery and do...

The polks are not bad speakers. I am not a big fan of MB quart ever since they were bought out by Maxsonics. Rockford is coming out with some decent stuff now but usually you have to get the upper crust, and ID has had some problems in the past few months. I dont want to come off as an audio...

I would warn you against putting those tweeters directly into the HU. If there is not a really good crossover built into your HU your going to be pushing frequencies into the tweeters that will tear them apart. Next, you have the ability to to hook LOC for each amp into the factory wiring to...

To start, there isnt anything wrong with having 0/1 for big 3 and 4 to the amp. As long as the wire to the amp can handle the current the amp draws your in the clear. Depending on what you are looking at in the future, if the wire is not already pulled, going with 0/1 to the amp location will...

Are you sure you have a GMOS-01, I thought the BOSE needed a GMOS-04 or something of that nature. Been out of the game to long. But I believe the section in the guide posted above about the pot need to the wire harness still applies.

I know that all 2013 EX models come with the premium sound, but not navi standard, not sure about your 2012. Do you have a subwoofer in the rear dash, if so it is premium. If that is the case the wires coming out of your HU are diff. balanced and useless to you. Here is where the problem...

I believe if you open the module up there is a little POT that you can use to adjust the output level.

Alpine made this unit pretty much impossible to bypass without sophisticated products like the Pac. Here is the thing, within the programming of the unit there are timers that increment with each action. If I remember the system must see the break wire within 3 seconds after power on, then...