Recent content by _Dejan_

Here are few photos with new alloys

Illumination: And the video how buttons work in conjunction with CarPC: Im not show Voice Recognition button because I do not have a microphone connected to the CarPC...

Im install and connect new steering wheel ... First one picture of the original steering wheel: Removed the original steering wheel and a spiral cable: In the connector is necessary to add 3 new cables CAN A, CAN B and lighting: New spiral cable is installed: Work is completed...

So need to work on ... What to replace? Tomorrow I will replace the steering wheel with a new multifunction steering wheel... First Im find a new spiral cable because the original is missing three contacts: Steering wheel: The new steering wheel seems to have enough buttons to operate...

I will not show CAN diagnostic messages on LCD I will sniff CAN messages, decode it and do actions(Play/pause, next song...) show values on screen(temp, speed, odometer, fuel consumptions...)

Then Im figure out that my Intel SSD has die too and Im replace it with new one: Closed case: All connectors which I need it(Wifi, GPS, USB2, USB3, eSATA, optical audio out, CAN, Video...) are here: And mounted case:

Long time ago Im update my thread and Im change few things... First Im change brake pads and rear discs: Because my carpc has stop working Im decide to buy and build new one: First Im take my old AM/FM radio device and little modify it: Then Im add CANUSB device which get CAN data...

Software: Input gain: Parametric EQ on input (Same is on each output): Crossovers: Output gain, time correction and phase: One board will be used for TW + MID another one for MIDBASS + SUB, third is input board(optical or SPDIF)...

Here is something new what I will test and install into car when I came from vacation:

I think it is time to little update my thread First Im replace my sound card to new one: Then Im install 10Hz SparkFun Venus GPS module. Normal USB GPS have update rate 1Hz which mean that update position every second. This module update position 10x in one second... Because TTL 232R...

Hi, Currently nothing special in my garage For car Im buy 15" alloy's and Goodyear UltraGrip 7+ tyres... Here is another toy which I have Also this winter I have plan damping car...

Today Im make new mesaures with less noise In my previous post Im change pictures with new results(Except noise graph)... Here is few new results... SUB (Full Range): Left MID+TW(MID: 63Hz3kHz - BugPass TW: 3kHz - BugPass): Right MID+TW(MID: 63Hz3kHz - BugPass TW: 3kHz - BugPass)...

Today Im try mesaure my system with TrueRTA and get next results: First mesaure noise in car: Im not shure if dB is ok I think it must be cca. 10-20dB lower... Then Im mesaure Left MID (Full Range): And Right: Tweeter(BugPass filter at 1.5kHz you can see slope)... Left: Right...

Audison Connection SFD41C

Today my boot look like this: Im turn on amplifiers and play trough phone because Im searching which cable go to which speaker(unmarkedcables.press)...