Recent content by 98dime

The box is done! Just have to run all my wires for my amp and put it in. Sometime next week hopefully. - trim to cover seams, going to be replaced with a diamond plate sheet soon hopefully. Have a way to keep it from rattling.

Very nice!

I made 2 blocks to space it so it will sit level, im going to cover them in the same fabric, wont even notice they r there. i didnt want to cut the box so it would fit the floor, i would prolly screw it up. lol

yup, it fits perfect, dont even hve to cut my jack bracket out, seats all the way back no clicks lost.

Yes its mdf, it wont flex its strong enough for my fat *** to sit on w/o flexing. Dont have a router, i used a jigsaw but its a pos, and i made hole one 2/16 bigger b/c i read my measurements wrong. *It's all good. Good enough for my 1st box and better than a bought sealed one. Carpeted some...

Here she is, all done except for carpet, im going to find some pretty soon. Did have a litttle trouble with one of the holes, cut it a little too big but its not a problem and still seals up fine. - made sure it was seald up. lol

OK got it pretty much done today. Just have to cut out the holes for the subs, put the back on, finish sealing it up, and carpet it and it'll be done. - Port peice looks crooked in this pic but its just the camera angle. - the back peice

On the link where does it get the 12.5" height from if it is supposed to be 14"?? Should i just ignore the 12.5" measurement and change it to 14"?? Board Dimensions and Quantity Color Count Width Height Top and Bottom 2 41 inches 19.75 inches Red 1 36.25 inches 12.5 inches Yellow...

Ok thanx man, i really appreciate your help!

1998 s-10 extended cab

Can i use these boxes facing up without any trouble??? Sorry im a newb to the car audio world. Can somone please answer my question above. It'll be greatly appreciated. or design a box for these subs with a center port to specs?? Please newb needs help.

Infinity Reccomends 2 cubic feet per sub with driver and port displacements. have it narrowed down to 2 plans here can someone check and see which design would be best???????? http://img10.imageshack.us/my.php?im...25sqin26rm.png http://img10.imageshack.us/my.php?im...25sqin24qz.png once...

what thickness of wood do those plans use 3/4" or what??

What can i use in place of terminal cups??