Recent content by 858SD

Maybe a more general better question, kinetic hc pro vs xs power xp batteries?

New to this forum I just want some opinions. I already searched on here I seen most people go for xs power over kinetic but I just want some opinions on theses specific batteries which I haven't seen yet. I will be running jl audio 1000/1 and jl audio 450/4 with either a 15 inch eclipse...

its at 100hz on the headunit but maybe around 80-90 on the amp. 100hz on the headunit seems to sound the best for me but it gives me an option of 60,80,100,200

I forgot what brand but i got it off ebay for around 20$ for the whole amp kit. I have had it hooked up for about 2 years no problem when i had it hooked up to one amp. Wire never got hot, fuse only blew once but thats when it had a 60A fuse. I now have a 150A fuse coming from the battery. Even...

personally on the headunit i would leave the sub level at 10 and then set the gain on the amp to however loud u listen. I like to leave room since some songs bass isnt as loud as others. I have never set gains with a multimeter, I find it more easy and simple to just use your ears. But heres a...

The sub wiring is good, The sub level on the headunit is at 15 but when everything goes good i have it at 10 also to leave room for weak bass in some songs

I just put that alpine in and im still getting no bump!! Idk wheres the problem at. I will add that when i turn up the Bass on the headunit the sub gets loud and good to where i want it. But i shouldnt have to do that as that means more bass coming to my speakers too. The bass on the headunit is...

Alright I will try the alpine tommorow, and if im correct my sub is now wired at parallel, and is my sub now 2 ohms or still 4 ohm sub wired to 2 ohms?

My sub wiring looks exactly like this..http://m.seimg.net/product/img/subwoofer_wiring/1_sub_DVC_4_ohm_mono.jpg, im still teaching myself on series or parallel wiring so idk which wiring it is..And on the sub amp Its just connected to the 1st Positive and 1st Negative terminals...It has 2 pairs...

What pics should i put up. the wiring inside my sub box or just the wire going to my sub amp or just my whole amp set up

sorry to confuse you. I did ran one speaker wire and bridged 2 channels of the 4 and inside the box it looked like this ...."http://m.seimg.net/product/img/subwoofer_wiring/1_sub_DVC_4_ohm_mono.jpg" ..... but instead there was a positive and negative coming from one set/side of terminals hooking...

Alpine ida-x100 and i will check the wiring as soon as i can

However the voice coils are hooked up, its the same from when it was in the soundstream. I never opened up the box to see how its wired inside since i had the sub. I will do that when i get a chance. But as how i hooked it up to the amps each amp has 2 pos and neg terminals..I just connect the...

Im just tryna hook up one amp to that one sub. My sub is dual voice coil 4 Ohms at 750 RMS. When i had it hooked up to the soundstream i bridged two channels which gave it 1000 watts. What i did with the monoblocks was just simply hooked them up to my sub. I had the alpine which I heard of...

Should i try setting gains by using a volt meter and test tone? Will it really help, ive always just used my ears for setting gains and never had no issue, turn up the headunit to how loud i normally listen and then set the gain.