Recent content by 3viley3

Understood. The wording and the animation were contrasting since it showed the negative of the speaker still connected to the amp. Confusion on my part. I'm going to do some more testing now that you've given me more to work with. I hope I can append to this later with what I found. Again...

Thanks, I checked out the link and that helps a great deal. One question though... I must apologize right away for my lack of knowledge but I wanted to be clear. I would actually be testing the amp speaker output with the DMM on the + (no speaker) and the - with the speaker plugged in? Either...

Good question but no, they are SVC.

In regards to phasing, the box is a sealed 2 chamber so they shouldn't be affecting one another. I also don't see how a mis-wire could be the culprit since after I switched the small-firing sub from left channel to right and secluded it from the other sub, it worked fine. To add to that, after I...

Power not distributing evenly (full power to one sub, other sub is moving but hardly noticeable) Amp: Rockford Fosgate P8002 200W x 2 @ 4-Ohms RMS 400W x 2 @ 2-Ohms RMS 800W x 1 @ 4-Ohms bridged RMS Subs: Two 12" Punch P3L-S12's. 4-ohm load Amp is set to Low Pass at about 50Hz. No...