Yeah I know it was overkill, this is the design I paid for.....fuccking huge waste of 10 days and $40....and i used galvanized pipe because I wanted it to look good, and i usually skimp on bracing, so I figured this time around I'd make sure I did it the right way, and because that's what I see people use in larger builds, so i went with that.....and dowel rods are to damn expensive....and pointless in my opinion. And I used sanded plywood because its lighter than mdf. Birch is to rich for my blood, and again I see no point in using wood that damn expensive lol....pointless, anyways....and as for the aeros, I tried flaring some 8" pvc I got for free and I was unsuccessful lmao....and ive seen those big ass ports that are adjustable.
But wouldn't i need atleast two or three of them? Thats to much for ports lol as far as money goes.
My port is 20 inches wide, 5 inches tall, and 20 inches deep
I didnt even waste my time on building that one, I made one that comes up 23 inches in the front and the port is facing towards the front seats.....but what I didn't realize is when i dropped them in the box the negative came unhooked from one of the coils and i played it for a couple minutes like that, so now I have to order a new recone kit for one of them. Because it rattles now when I play it.
I'm so fuccking pissed off, finally after 3 years of owning these and going through vehicles and then something so stupid happens and the coil fries....just my luck