Rca??

  • 1
    Participant count
  • Participant list

97civicsedan
10+ year member

Member
A while back i had my system hooked up by circuit city, and today i just replaced my sub and i noticed that in the middle of the rca's line one of the two rca wires was snipped, so i tested them and only 1 worked, my question is it works perfect now with only 1 rca plugged in but will it make a large difference in sound quality???

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

No make or model number on it? Do you have an exact picture of the rear and all its glory?
8
851
Use two sets of RCAs. One set for the Front channels and the other for Sub Output and into Rear Input on the amp. Turn off the Rear Filter on the...
5
879
Thanks a ton for your suggestion to my rather long query, I ll follow it and see how it works out. Thanks again
2
741
He'll be fine with any 4 ohm speakers, tuned properly. The focals are rated for 100 watts nominal and with the passive crossovers and power to...
6
843
Try this other test; get a 3.5mm headphone repair cable and connect it to the LC7i input. Connect that to your phone and measure. This will tell...
11
940

About this thread

97civicsedan

10+ year member
Member
Thread starter
97civicsedan
Joined
Location
Glendale, AZ
Start date
Participants
Who Replied
Replies
0
Views
386
Last reply date
Last reply from
97civicsedan
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top