-
2Participant count
-
Participant list
Most amplifiers do much better with plenty of air flow under and around the Chassis. Placing 4-6 washers on each mounting tab to raise an amplifier off the surface helps to keep an amplifier to run a bit more cooler,and a fan as well is a very nice addition to dissipate heat of which we all know is a death sentence for electronics. Id place the amplifier in a location that gets air flow and doesnt retain as much heat.
Activity
No one is currently typing a reply...
Similar threads
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
- Started by chris123
- General Car Audio
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
- Started by William Melcic
- General Car Audio
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
- Started by RyanJ0022
- General Car Audio
- Locked
COMPLETED
WTB - Small Mono Amp WxDxH
NVX MVPA1
Best tiny amp
Installed a bunch, but have one pushing a sealed 12 @ 2ohm in my daily beater
Can bump it all day long and barely gets...
- Started by AnthonyO
- Car Audio Wanted
This tested well on youtube - not familiar with the brand but it is a pretty standard china build house amplifier...
- Started by saints747
- General Car Audio
About this thread
New threads
-
WANTED Down4Sound MM1004 GrayWould like a gray D4S MM1004 to match my other gray MM1004...
- Started by kenvicta
- Replies: 0
-
What's this worth?Going to go on a different direction when I get my new...- Started by chillin
- Replies: 2
-
-
Multi speakersHello all, need some wiring advise for some speakers. I have...- Started by 07FLSTC
- Replies: 2
-
Yamaha Ypa-700!Scored this on ebay. Listed as untested. They accepted my...- Started by metalheadjoe
- Replies: 1