Help

  • 2
    Participant count
  • Participant list

Doomroomceo

CarAudio.com Newbie
1
0
VA
I have a 2000 rx 300 with factory unit hooked up to kenwood 1000 max 600rms powering a 10inch p3. My problem started earlier when i lost all power to my amp. Now my amp cuts on when i cut off my car totally even with key removed when i cut the car back on with the radio the amp goes off. I have a converter hooked up to my back door speakers that has 2 sets of speaker wire a ground a remote a 12 v and output outlets can any body assist
 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Got it figured out! Thankfully a friend just found out about KunKonceptz UBT-20 terminal adapters that allow multiple connections to my type 94...
3
169
Turn the volume completely down and operate ot normally. This is to see if it is the built in amplifier that is shutting down. If the radio does...
1
269
That would be a function of the harness, not the HU, I think. Have you looked into a Maestro or iData interface? i would check with crutchfield...
12
455
Dammned good speakers. Just pass up the CL series,and you will be pleased with CDT speakers. I still enjoy all mine. Polk MM series and Infinity...
4
427

About this thread

Doomroomceo

CarAudio.com Newbie
Thread starter
Doomroomceo
Joined
Location
VA
Start date
Participants
Who Replied
Replies
1
Views
683
Last reply date
Last reply from
Popwarhomie
Buick Amp Connector.JPG

maylar

    Jun 2, 2024
  • 0
  • 0
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0

New threads

Top