Jonnyswboy
CarAudio.com Exclusive
- 448
- Thread Starter
- #16
Agree. Taramps MD3000 with Fi SSD. Add a rear battery in you can or upgrade your front battery.
Thank you for the recommendations! I am going to go with an MD 3000.1 and the SSD in a 3.2cuft ported box. I think I'm going to hold off on the battery upgrade for now though, I will just have to be thorough when checking voltage and adjusting power.meh chinese low quality board. dynos 2250 costs 230$
taramps md 1800.1 dynos 2450 costs 180$
taramps md 3000.1 ^ you can pretty much see how much power this should dyno at. costs 205$ and it has a remote clipping indicator as well. The skar is no where near a taramps HD 3000.1 from my IRL tests output, efficiency sound quality etc.. and the MD series is much stronger than the HD series.
And just to clarify I should still buy the dual 2 ohm sub and run it at 1 ohm right? Or should I buy the dual 1 and run it at 0.5 ohms? Also you said that people wire their amps to 0.25 ohms. Do you mean wire the sub down to that? How would you wire down an amp? And sorry last question I promise but do you think a 16ft power wire is long enough to do a clean install under the plastics and possibly the "big 2" that you recommended (2010 Mazda 6 Sedan)?
Last edited by a moderator: