Can’t wait to install it.
Birth sheet on new amp!!
- Thread starter Dragonsyph
- Start date
- Replies 0
- Views 856
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
Yeah I had torn one down and used my digital calipers to measure coil size ID & OD and winding height and spiders all had it written down and had...
- Started by BigMan813
- General Car Audio
Here is a chart that gives you relative cone size.
Diameter of speaker*|*Cone area of speaker in square inches
18"*--->*254
15"*--->*192...
just use riv-nuts or clip-nuts, made for blind fastening. some window weld should hold the ring on there pretty good..... being 4x6, you could...
- Started by HardofWhoring
- Enclosure Design & Construction
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
- Started by William Melcic
- General Car Audio
About this thread
New threads
-
Which am has better sound quality?I was wonder which one of these amplifiers has the better...- Started by 6r33n3y3z
- Replies: 1
-
After market stereo wiringI'm having issues color coordinating my wire colors on my 05...- Started by Darrell Robinson
- Replies: 3
-
WANTED 4 gauge OFCLooking to buy some 4 gauge OFC. Let me know if you have...- Started by AnthonyO
- Replies: 1
-
Another VS ThreadLooking to go for a cheap SQL build in the back of my Jeep...
- Started by Blackout67
- Replies: 16
-
Running two pairs of component speakers activeHello everyone. I need some advice. I am considering...
- Started by 6r33n3y3z
- Replies: 10