I have a 2014 Hyundai Santa Fe sport stock alt, a kisloc2 for stock radio support running all ofc wire into a Jensen 600w amp at about 240x1
@ 4 ohms. With that running into a dual 4ohm 150w each rms kicker c12’s. All wire is ofc, and is the appropriate gauge with power wires that fit the terminals perfectly. Everything is going good until either the bass hits super hard, or I turn it up past 25 or 30 out of 45. The bass begins to cut out and make a popping noise. The amp isn’t going into protect either. I’ve reinforced my grounds, and upgraded all wire. Idk what the issue could be at this point.
@ 4 ohms. With that running into a dual 4ohm 150w each rms kicker c12’s. All wire is ofc, and is the appropriate gauge with power wires that fit the terminals perfectly. Everything is going good until either the bass hits super hard, or I turn it up past 25 or 30 out of 45. The bass begins to cut out and make a popping noise. The amp isn’t going into protect either. I’ve reinforced my grounds, and upgraded all wire. Idk what the issue could be at this point.