dylanmurphy23
Junior Member
Okay so a few months ago I changed amps from an MTX amp that came with my Dual 12 inch MTX Terminators. I switched to a BOSS R6002 1200 Watt Amp (2 Channel). After installing this amp I noticed that my subs were noticeably quitter, less of a bang and they distort and the amp goes into protection mode. I've been reading online to try to find a solution to this and all ive been seeing is stuff about the ohms. My subs are 2 Ohms and the amp is 4ohms but it also says 2 on it, I don't know which is it I will post a link below. I have these subs bridged and I was wondering if this is a stable ohm load. I'm not very knowledgeable on this stuff so if someone could break it down for me that would be nice.
I really don't know how well I explained this, but I hope someone can help me out! //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif
Link to Amp Specs. and ill also post my subs.
Boss Audio R6002 RIOT 1200W 2-Channel MOSFET Power Amplifier with Remote Subwoofer Level Control at Onlinecarstereo.com
It says max bridge 4 ohms, does that mean I cannot use this amp with my 2 ohm subs?
My subs
MTX Terminator TNP212D Amplified Bass System With Two 12" Terminator Subwoofers In a Sealed Enclosure at Onlinecarstereo.com
I really don't know how well I explained this, but I hope someone can help me out! //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif
Link to Amp Specs. and ill also post my subs.
Boss Audio R6002 RIOT 1200W 2-Channel MOSFET Power Amplifier with Remote Subwoofer Level Control at Onlinecarstereo.com
It says max bridge 4 ohms, does that mean I cannot use this amp with my 2 ohm subs?
My subs
MTX Terminator TNP212D Amplified Bass System With Two 12" Terminator Subwoofers In a Sealed Enclosure at Onlinecarstereo.com