Recent content by yroc434

Ok i will check them out

Custom tuned @34hz

Ok cool.... Which one?

Sundown's recommendations

SQ from the Type R seemed better to me and the R seemed to hit harder do t get me wrong the SA's get down but i have been Type R forever and I finally tried something else for once! Im running the SA's off of a CAB1600.1 @1 ohm and i had the type r's on a hifonics brz1800.1

I just like the SWR12D4, these SA-12's were the first set of SA's i owned an i like the type r better

looking to trade my SA-12's in a custom ported box made by Cherryman Customs tuned @34 hz, for a set of Alpine type R's (SWR-12D4) in a ported enclosure! PM for my phone # since idk how to upload pics but i can text them to you! Subs & enclosure are less than a month old as i just want to go...

Thanks for the info Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

ok i have a CAB 1600.1 pushing (2) SA-12D4's wired down to 1 ohm! my amps settings are as follows: Gain (goes from min-max) LPF ( 40hz-180hz) Subsonic (off-50hz) Bass Boost Frequency (30hz-80hz) Bass Boost (0db-12db) now where are these settings best set to? i hear not to use the Bass...

Ok i have a set of SA-12 D4's wired to 1 ohm pushed by a CAB 1600.1 and sounds great! Now i have a question on the enclosure i want them in! Sundown says 2ft^3 and tunned to 34 hz! Now im wondering about (2) different enclosures! First is a ported 4ft^3 single chamber tunned at 32 hz and the 2nd...

ok cool, thanks bro

1/0 gauge power wire 1/0 gauge ground (2) SA-12D4 Rev.3 subs CAB 1600.1 amp now here is my question... i want to wire these down to 1ohm! as far as speaker wire, what size should i use to wire these up? i was going to use 12 gauge but the jumper wire and the positive wire joined is to big...

I got it!!! Works perfectly now!!! The remote wire was ripped in half (not sure how that happened) but everythings a go now!! I never ran into an amp not turning on for me so i said ok imma strip out everything and check wires for rips and bare copper per trudging and it was the remote...