Recent content by dB-r

  1. D

    Amplifier repair suggestions

    Is this the MM4000 that is coming here? It is a little on the old side, but we do still repair this model, have a customer sending in one right now.
  2. D

    Running an amp without back cover..

    from MS. Google 98HOEONSIXEZ
  3. D

    Running an amp without back cover..

    I'd advise against it. I once worked on 4 SAZ-4500D's installed without the bottom covers, from a well known install that all had something get inside the amps in the car that was conductive and rattled around inside, when it landed across the high voltage (300-400VDC) in the output section it...
  4. D

    Amp got wet, is it ok?

    Yep, as long as you let an amp dry completely out (putting it in the hot sun directly with no cover on) before powering it back up, it will not hurt anything moisture can corrode parts YES, and can rust parts YES, but can tell you this, on amps that are extremely dirty, or extremely burned up...
  5. D

    My amp wont turn on help!!!!!!

    Wow, just wow. Thanks! ;-)
  6. D

    My amp wont turn on help!!!!!!

    That IS a fact. Since day one if you read them all. I do contribute. I don't have the best manners however. ;-)
  7. D

    can a 4 gauge wire damage an amp

    Wow this got out of hand. Lots of FIAL in this thread. Anyway, question. WHY will CCA burn your car down? I think that's what's in my car, and I have run anything from a SAX-100.2 - SAZ-2000D on that wire and never had a problem, since 2010 or so I guess. Please explain. I'm no wire...
  8. D

    My amp wont turn on help!!!!!!

    Yeah, well I have a PhD in amp repair. LOL. Just trying to help, starting to remember why I don't come here often anymore......
  9. D

    Amp ?

    Wow. If they figure out how to get 2000W out of only 80A in the 12-15VDC range, I want in on that, could put the power companies out of business with that technology! That sounds more like it! I think that was the old MMATS. I don't know about the new MMATS, seems from what I have seen they...
  10. D

    Advice needed on a 1 ohm 1000w amp for around $200-$250..Pioneer GM-D9601 ?

    The Refurbish work we do is far beyond what the other companies do. We actually go over what's there and rebuild entire sections of the amps, the others either put a whole new board in (which may end up with same factory failures as the original did, because something need attention, may just...
  11. D

    Advice needed on a 1 ohm 1000w amp for around $200-$250..Pioneer GM-D9601 ?

    Our Refurbs are 1 YEAR WARRANTY BTW. just saying. Reading = Winning the SAE-1200DV2 is good for 1300-1500 in the 12V range, 14.4 good for 1700.
  12. D

    Amp ?

    If used properly the Bass Boost won't hurt anything, but the key is "if used properly". Though shouldn't need it with most modern head unit's it's builtin to the settings and configurable however you would like it. Not all head units though, but most have at least LPF freq and sub level...
  13. D

    Hello new amp!

    the RF 4 channels are cheap because there's not much in there. Class D subwoofer amps require big coils (with big cores and lots of expensive enamel coated wire wrapped around them) and big capacitors too. Makes the cost go up quite a bit from your average small 4 channel AB amp. Where did...
  14. D

    My amp wont turn on help!!!!!!

    Whatever, you got lucky that it worked, 99% of the time bad drivers and more, not just bad mosfets. People act like I don't know wtf I am talking about or something.... Misinformed to say the least. Sorry if I gave the wrong impression, I just see people try to do exactly what you did all the...
  15. D

    Hello new amp!

    The Rockford amps are nice except for the price. The SAZ-1500Dv3 is a little beast. Most people don't know it, but it's exactly half of a SAZ-4500D.
Top