Amp turns on, won't power subs.

  • 6
    Participant count
  • Participant list
I have a Legacy LA770 500WX2 CH amplifier with two Memphis 12" subs. The amp will power on and everything, but I have no sound out of the subs. I've tried so many things, different RCA cables, different ground, and everything. The biggest thing here is that I hooked up the subs to another amplifier and they worked fine, they hit hard and everything. I had everything set up the same. So what is my problem?

 
I mean the RCA's on the amp itself (The input on the amplifier). Sorry to say it, but Legacy is near the bottom for quality of construction. I have one in my closet next to a Pyramid amplifier (First two my father bought when I was in highschool). I wouldn't be surprised if it was defective.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

It might be "ghetto" by today's standards but I used to run a wire off the battery to a switch then to the amp...back in my youth the Police liked...
15
4K
Using Sky High copper OFC wiring and Stinger 8000 series rcas. The US Acoustics usx4085 is rated at 85X4 @ 12.9 volts and proably close to 100w X...
6
166
Subs play to the beat with gain low but if I turn it up my subs play loud unwanted never ending bass that is constant and wont stop until I turn...
0
83

About this thread

ralph42794

Junior Member
Thread starter
ralph42794
Joined
Location
Parkersburg, West Virginia
Start date
Participants
Who Replied
Replies
8
Views
20,294
Last reply date
Last reply from
Pataforce8
Screenshot_20240614-101246_Google.jpg

chillin

    Jun 14, 2024
  • 0
  • 0
24 civic.jpg

Popwarhomie

    Jun 12, 2024
  • 0
  • 0

New threads

Top