Hey there guys and gals!
So I bought this amp which will soon replace my faithful old Precision Power PC450. I am using my stock head unit since it has provision for rear view camera so don't want to change that. :blackeye: . The Hertz amp will be running Boston components and Rockford co-ax in the rear deck.
Now currently the remote wire is connected to the accessory so the amp remains on until I pull the key out. This is the main reason I will be swapping the PPI amp to run my speakers. The Hertz has signal sensing through speaker outputs so I will be running speaker wires to connect to the amp. Which brings me to my question, how will I send a remote signal to turn on the monobloc amp, (a Phoenix Gold RX1100.1) :blackeye: after I have changed to the Hertz amplifier???
The Hertz amp does not have provision for a remote out so presently, I am doing my homework before I attempt the replacement task. :graduate:
oh!,I have been lazybum not reading the 50 page manual but I think I will have to :crap:
Any ideas guys??
So I bought this amp which will soon replace my faithful old Precision Power PC450. I am using my stock head unit since it has provision for rear view camera so don't want to change that. :blackeye: . The Hertz amp will be running Boston components and Rockford co-ax in the rear deck.
Now currently the remote wire is connected to the accessory so the amp remains on until I pull the key out. This is the main reason I will be swapping the PPI amp to run my speakers. The Hertz has signal sensing through speaker outputs so I will be running speaker wires to connect to the amp. Which brings me to my question, how will I send a remote signal to turn on the monobloc amp, (a Phoenix Gold RX1100.1) :blackeye: after I have changed to the Hertz amplifier???
The Hertz amp does not have provision for a remote out so presently, I am doing my homework before I attempt the replacement task. :graduate:
oh!,I have been lazybum not reading the 50 page manual but I think I will have to :crap:
Any ideas guys??