I have a 09 Saturn Aura XR (l4) and am wanting to take use of the other 2 channels on my amp. I have already amlified the rear deck speakers however i really dont want to have to take the door panels off to run new wire. So my question is where would you splice into factory wiring at? I googled a wiring diagram and it said that the front left speaker wires are gray and tan. So I took the trim off on driver side of vehicle and saw a gray wire, I cut this gray wire hoping that it would make the door speaker stop playing however it was not the correct wire. I really dont want to take the dash out again or take door panels off as that is a pain in the ass. any suggestions?
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
two d2 subs can be wired to .5 or 2 or 8 ohms
not 1
heres how to wire subs...
- Started by Hash4040
- General Car Audio
The big 3 in 1/0 redoing power and grounds in 1/0 should be good for what you're running...I'd start there and if you still have issues I'd look...
- Started by Oldbasshead
- Wiring, Electrical & Installation
Perfect thank you.
- Started by Sask84gt
- Wiring, Electrical & Installation
hi all, thanks for allowing me to join your site. im installing 2 soundstream tx4.560 4 channel amps, but i want to run them as 2 channel...
- Started by magikman
- Wiring, Electrical & Installation
With 1/4 wave and tuning low, your vehicle is a resonator itself, like if you think about from your rear hatch or back of the box traveling front...
- Started by Psi_optima12
- General Car Audio
About this thread
Latest topics
-
-
-
-
-
where to connect the Pioneers yellow mute wire?
- Started by HandsomeSteve
- Replies: 3