Lol I have a 2015 Jetta tdi with focal intergration speakers on an older jbl 4 channel amplifier. I decided to run it active passive to utilize my touchscreens time alignment capabilities. To clarify active passive that means each woofer gets a channel and each tweeter gets a channel but I left the crossovers built into the tweeters wiring there. It worked for quite a while but it seemed I got a wierd noise from the driver tweeter when I had it as loud as it could go undistorted. Now the amp goes into protection mode when it gets switched power regardless if the speakers are hooked up or not. It is a discontinued amp I would give the model name but I dont remember it
-
2Participant count
-
Participant list
phantom240 5,000+ posts
ALL YOUR INTERNETZ
Instant protect mode with no load sounds like a bad amp to me.
- Thread Starter
- #3
Activity
No one is currently typing a reply...
Similar threads
Yeah same here
- Started by infamous_e46
- The Thunderdome!
Me too and then I have to paddle anywhere I want to go.
- Started by toddington
- New Member Introduction
Got everything installed and running. It's definitely dragging my idle down a bit, I may bump my idle speed up a few hundred Rpm until the voltage...
- Started by mat3833
- Wiring, Electrical & Installation
those center spots shine out pretty far enabling me to see well on the dark highways.
- Started by JasoninDLH
- The Thunderdome! 2
About this thread
