"Junk in Her Trunk" VW R32

  • 5
    Participant count
  • Participants list
Do you have a CNC machine or did you do that all by hand?   How many sheets of wood did you burn up?
All done manually on a table router.

(2) 3/4" sheets

(2) 1/2" sheets

(1) 1/4" sheet

I'm also making templates of all the pieces so I can do my R32 next

 
Fab work done. Magnets installed on forward and rear edges of trim panels instead of visible hardware. Handing off to the owner's boyfriend for the air tanks, hard lines, and upholstery then back to me for the rgb led lighting for the subs, air management, and the acrylic window which will be laser etched.

IMG_6092 by Jon Polo, on Flickr

IMG_6093 by Jon Polo, on Flickr

IMG_6157 by Jon Polo, on Flickr

IMG_6158 by Jon Polo, on Flickr

IMG_6230 by Jon Polo, on Flickr

IMG_6193 by Jon Polo, on Flickr

IMG_6195 by Jon Polo, on Flickr

IMG_6192 by Jon Polo, on Flickr

IMG_6199 by Jon Polo, on Flickr

IMG_6238 by Jon Polo, on Flickr

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I too generally use the factory carpet to make my templates. It's also a good idea to put layer of butyl damping material under the MDF too...
7
646
If the amp is already part of the unit, with the amp built in, you would need a power supply, something like this: Or sell that amp amp and...
2
871
It will probably change your tuning. I've seen bigger numbers off of much less power from walling at the rear seats, but Terry "trunk king" Brock...
1
874
Thanks all for your responses! In regards to the dB meter suggestions, I ended up using my Blue Yeti microphone which supposedly can handle up to...
4
1K

About this thread

crnacnac

10+ year member
Senior VIP Member
Thread starter
crnacnac
Joined
Location
Pasadena,CA
Start date
Participants
Who Replied
Replies
17
Views
2,013
Last reply date
Last reply from
crnacnac
Screenshot 2024-03-07 184329.png

Doxquzme

    Mar 27, 2024
  • 0
  • 0
IMG_3075.jpeg

Daniel Lee

    Mar 27, 2024
  • 0
  • 0

Latest topics

Top