Von Barrett
CarAudio.com Newbie
- 3
trying to find best way to wire 6, 4 ohm speakers to a 4 channel amp. New to all of this so bare with me. Have 2 twetters and 4 mids I want to hook up to 4 channel amp. Any thoughts? Thanks V
Speaker ?sss
- Thread starter Von Barrett
- Start date
- Replies 2
- Views 380
-
2Participant count
-
Participant list
n2audio 5,000+ posts
OPTIDRIVEN
I'd probably just use the amp for the speakers and run the tweeters with the HU and appropriate HP filter.
If this is an unconventional configuration w/o a HU I'd probably run the 4 speakers with 2 channels (wired parallel) and run the tweeters on the other channel.
Tweeters would still need a filter. Not many amps have a high pass that goes high enough.
If this is an unconventional configuration w/o a HU I'd probably run the 4 speakers with 2 channels (wired parallel) and run the tweeters on the other channel.
Tweeters would still need a filter. Not many amps have a high pass that goes high enough.
- Thread Starter
- #3
Thank you much I appreciate the information I'll try and see how that works out
Activity
No one is currently typing a reply...
Similar threads
Drill a hole and use the proper protective split loom and hole grommets to keep the outer speaker jacket from knicks and cuts, give just enough...
- Started by Red Dog
- Wiring, Electrical & Installation
I'd be willing to pay for a quality HU, if it meant that I can truly get the sound quality I need. I've seen some aftermarket ones that look...
- Started by Cristian Borrageiros
- General Car Audio
You could do the 8" as a front sub on its own amp and use it to bridge/enhance the gap between your 12" in the rear to the midranges
- Started by Paul Personette
- General Car Audio
Takes the guess work out of it.
- Started by ChillyWilly72
- Amplifiers
About this thread
Latest topics
-
-
-
-
-
where to connect the Pioneers yellow mute wire?
- Started by HandsomeSteve
- Replies: 3