So I could start off with a back in my day statement but I think the title covers that.
AMP - JL Audio JX 1000/1D
2x 10tw3-d4
Going in a custom built box for my truck. Going to end up with .6 CU FT per chamber a bit more then the sub needs.
here is where I am on the fence. They are 4ohm speakers I could wire them in Parallel dropping to 2ohms getting the full 1000w from the amp however the speakers only have an RMS of 400w
If I just wire direct at 4ohms I cut RMS down to 500w which is way under powering these subs.
Curious what you guys would do.?
AMP - JL Audio JX 1000/1D
2x 10tw3-d4
Going in a custom built box for my truck. Going to end up with .6 CU FT per chamber a bit more then the sub needs.
here is where I am on the fence. They are 4ohm speakers I could wire them in Parallel dropping to 2ohms getting the full 1000w from the amp however the speakers only have an RMS of 400w
If I just wire direct at 4ohms I cut RMS down to 500w which is way under powering these subs.
Curious what you guys would do.?