Jump to content

Sign in to follow this  
Muffdogg

Question about settings on a Pioneer AVH-3700BHS?

Recommended Posts

I have a 2008 Yukon Denali XL with a Pioneer AVH-3700BHS hooked up to the factory Bose amp and speakers. Also have an 15" SSA XCON hooked up to an FSD audio 1600. Box was designed by CSCSTANG. I have no idea about using the crossover settings on this. I've left them as they came with the unit. Any help would be appreciated. Thanks.

Share this post


Link to post
Share on other sites

in general set lp xover for sub at 70- 80hz (if u listen to rock set it at 100), ss filter just a little below box tuning freq, so if box tuned at 35 hz set it at 30 and hp for mids 80-120 (lower them til they don't distort).. if u have these xovers on hu use them on that not on the amp so on amp just set xovers to full range, off or set them to highest freq (if lp goes to 250 set it there and use lp on hu set at 80 or so)


KENWOOD X301 HU, PRECISION POWER Phantom 1000, FU 750 12, 2.1cfad ported, soundqubed 6.5" coax/doors, hp & lp xover on hu, AGM starting batt...

Boomin_tahoe said:
2 ohms rule

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×