-
4Participant count
-
Participant list
THATpurpleKUSH 5,000+ posts
Fuckyou
What size wire are you using? You normally fuse for the capacity of the wire.
BOOMINGRANDPA 5,000+ posts
WOLFRAM FTW
300 is way too big, if you ran a 300 amp fuse on that amp you might as well run straight wire. 150 amps is big enough.
BOOMINGRANDPA 5,000+ posts
WOLFRAM FTW
y most 0ga amp kits come with 250-300a.. i've always said to go smaller like u say 150-200 but they come with bigger usually
BOOMINGRANDPA 5,000+ posts
WOLFRAM FTW
well 150a fuse good for about 2k but u just gotta fuse for the wire..
I owned one before my 2500, I used a 150 amp fuse
THATpurpleKUSH 5,000+ posts
Fuckyou
I fuse for the current capacity of the wire rather than what the amp would potentially draw, 300a for 0ga ofc and 250a for cca.
Activity
No one is currently typing a reply...
Similar threads
Should be good to go without those fuses. Read the manual that comes with the new stereo. If it doesn’t say to add additional fuses, don’t.
- Started by Kyrk
- Wiring, Electrical & Installation
It would be cheaper, it might be easier to find a place to mount it, and you would have a ton of options if you just do two, 3 slot fuse holders...
- Started by .........
- Wiring, Electrical & Installation
My bad, yes, I read them each as having two 4ohm coils. The JBL diagram left a bit to be desired, IMO. ;)
And a double yes, thought U was talking...
- Started by Wolkt
- General Car Audio
About this thread
Latest topics
-
-
-
-
Help With Kenwood DDX9907XR / DMX907S - Kenwood Technical Support Can't Help
- Started by fadetoblack73
- Replies: 5
-
