- Thread Starter
- #2
Last edited by a moderator:
- Thread Starter
- #3
Louisiana_CRX 5,000+ posts
dem shoes......
Did you use a laser cutter on those ?
- Thread Starter
- #5
Cnc turret punch. Just as accurate as our lasers
If i were going to make something like this, I'd round the bottom of the input into the amp and maybe some sort spot on top for the set screw of the amp to clamp down on better. Other than that, should work.
- Thread Starter
- #7
It's aluminum. I have a offset punch tool I'll try.
Activity
No one is currently typing a reply...
Similar threads
Is the sub still for sale?
- Started by SnoringDad
- Car Audio Classifieds
THANKS i can make that work this really helps big time, appreciate it
- Started by basshead79
- Enclosure Design & Construction
Whoa, that will be one skinny port. The width of the back wall ports will be 1.08" wide (27.5mm), but the front port will be shared by 2 subs so...
- Started by MitchnSystem
- Enclosure Design & Construction
Assuming the box is made of .75" MDF the 12"x20"x15" box is 1.5 Cu Feet. The 33"x19"x15" is 4.3 cubic feet, something is not right here. JL has...
- Started by Mission Shane
- Subwoofers
Recoil 2500.1 $179 2500 x 1 @ 1 ohm. Make sure subs are the dual 4 ohm version.
If you don't want that much power, get the Recoil red1200.1 for 1...
- Started by Ljaudio5281
- General Car Audio
