How to wire two dual 4 ohm subs to 2ohms?

2 dual 4 will give you 1 ohm or 4

Hey guys, I have two dual 4 ohm subs and I want to wire them to run at 2 ohms on a monoblock amp.
Is this possible? I've read in a few places that it's not.

Click to expand...

Cant be done. Your options are 1 ohm and 4 ohm.

Subwoofer Wiring Diagrams, Two 4 ohm Dual Voice Coil (DVC) Speakers

Subwoofer Wiring Diagrams

Click to expand...

Beat ya to it. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

I guess the only way to really get a 2 ohm load from a pair of dual 4 ohms is to use 2 amps. Each one running 2 ohms. It's more complicated this way and kinda pointless if you ask me. You're better off running at 1 ohm with one amp though as it's the best bang for the buck. If your amp is not 1 ohm stable, then get one that is. Otherwise getting a lot of power at 4 ohms is expensive. Some of the old school amps you could bridge at 4 ohms though, which is just as good.

You can short one of the VC's on each sub (jumper + to - on one VC and don't connect it to anything else). Then you can wire the other VC from each sub in parallel to get a 2 ohm load.

IF you do this, then derate your power by ~75% to be safe.

I ran a JL dual 4ohm VC sub like this for years without any issues at all. The theory behind shorting the unused VC is that it increases damping so the sub & enclosure behave roughly the same way it did with 2 VCs wired.

There is a paper written about the theory on this somewhere - I will look for the link later.