-
5Participant count
-
Participant list
biglion
jasonbillnelson 10+ year member
LEAD, FOLLOW, OR GTFO!!!
3 prong will let you have 12v power in - A or R is for accessory/remote(middle prong) and then Ground. Power wire from your battery bank to 12v in, power wire from your volt meter to the accessory/remote(middle prong) and then ground that volt meter. Then ground wire from your toggle switch to a ground.
jasonbillnelson 10+ year member
LEAD, FOLLOW, OR GTFO!!!
maylar 10+ year member
Electrical Weenie
What is it you're trying to accomplish?
OP
biglion 10+ year member
Senior VIP Member
- Thread Starter
- #7
basically i have 2 led 12 volt meters i wanted to hook up so i could monitor voltage on amp and battery and i wanted to add rockers switch
Mini Digital Voltmeter 0-100 VDC BLUE LED Panel Voltage Meter with Three Wires
maylar 10+ year member
Electrical Weenie
You want a switch to turn the meters on and off? You could just run the red wires to a switched ignition wire in your car, and the white wires to where you want to measure. Black to ground. No switch required.
If you want a rocker switch anyway, just put it between your switched ignition power and the red wires on the meters.
If you want a rocker switch anyway, just put it between your switched ignition power and the red wires on the meters.
You can also use your amp remote wire to turn them on and off and hot goes to + battery term For one volt meter then other + amp for voltage to amp then ground them both to something or - battery
Just like an amp.. A remote, a +, and a -
If it was a 2 wire volt meter then you would need a switch on the + cable to stop the draw
If it was a 2 wire volt meter then you would need a switch on the + cable to stop the draw
If you really want me to draw a picture pm me your number and I will with a switch if you want also or without
Activity
No one is currently typing a reply...
Similar threads
Use this for the PB bypass.
- Started by HandsomeSteve
- General Car Audio
Sweet!!!!!
- Started by ikpthegame
- Wiring, Electrical & Installation 2
Drill a hole and use the proper protective split loom and hole grommets to keep the outer speaker jacket from knicks and cuts, give just enough...
- Started by Red Dog
- Wiring, Electrical & Installation
It mostly comes down to weight. You can have a super lightweight cone, soft suspension and aluminum coil on a sub and you pretty much get a pro...
- Started by MrButtersworth
- Subwoofers
Yes . Until i get a 3.5 or 4 inch mid
- Started by Bass so loud it HZ
- General Car Audio
