I'm very scared this motor is shifted! Please let me know or if it will get worse or if its fine! Any help will be appreciated!
[/img]
Also it's no bigger than 1mm
Also it's no bigger than 1mm
Last edited by a moderator:
Help! Shifted motor!
- Thread starter Neily_OB_24
- Start date
- Replies 5
- Views 1K
-
3Participant count
-
Participant list
goingdef 10+ year member
CarAudio.com Veteran
That's not what shifts, it genrally the pole and or top plate, I think you're fine unless it rubbing them I would say there's damage to the coil/former.
- Thread Starter
- #3
The biggest measurement I could get is .400 I used a very nice caliber so I know it's accurate.
Last edited by a moderator:
goingdef 10+ year member
CarAudio.com Veteran
My brand new zv4 magnets are not perfectly stacked either, I think it's fine I would check the measurement around the gap and see if it's consistent.
- Thread Starter
- #5
Yeah it's pretty good it is hard to measure 100% but it's less than 1mm maybe less than .5mm actually
Activity
No one is currently typing a reply...
Similar threads
So I have a 12" 2500RMS 1ohm stable Skar Audio subwoofer paired with the corresponding Skar amplifier that pushes 2500RMS at 1 ohm. This is in a...
- Started by Joe Shmo
- General Car Audio
Honestly I don't think it would be hard for them to make it where you use android auto AND your own music source. They made it able to do so...
- Started by fadetoblack73
- Head Units
Agreed with this here. Since you have the unit pulled out of the car/dash...test it at your car battery directly for operation. very simple to do...
- Started by genasis coupe 3.8
- Wiring, Electrical & Installation
This may be an option for you as well. Im sure Amazon has them on theyre site also to be purchased. Great amps...
- Started by Chris Gerrish
- Amplifiers
Yeah, put the probes on the power wire and ground wire of the amplifier. Multimeter on DC.
Do not put it on the wires that go to your speakers. M
- Started by Mr FaceCaser
- Amplifiers
About this thread
Latest topics
-
-
-
Jeep center console sub install issues.
- Started by vlusardi
- Replies: 1
-
-
