Speaker wire disconnects
- Thread starter knotdrummer88
- Start date
- Replies 10
- Views 1K
-
8Participant count
-
Participant list
knotdrummer88
I like W.S. Dean's Ultra Plugs. You just have to heat-shrink and tape them up carefully.
TowerHobbies.com | W.S. Deans 2-Pin Ultra Plug
TowerHobbies.com | W.S. Deans 2-Pin Ultra Plug
SplAffair 10+ year member
I lol'd
I have a 98 cherokee as well. Are you using the stock speaker location?
OP
knotdrummer88 10+ year member
CarAudio.com Elite
- Thread Starter
- #4
Well, they're in the stock location in the sense that they're in the door. They are in fiberglass pods, and I also have two of the same sized mids built into the sound bar
OP
knotdrummer88 10+ year member
CarAudio.com Elite
- Thread Starter
- #5
Is each prong a for a negative wire and positive wire respectively?
bbeljefe
CarAudio.com Elite
If your music is in the doors why would you take the doors off and lose the music???? Might as well take the engine out too, cause the car ain't worth driving with no tunes innit. ;-)
But seriously... Neutrik Speakon connectors.
But seriously... Neutrik Speakon connectors.
logiball 10+ year member
Senior VIP Member
He has a separate sound bar it looks like
If you have a passive x-over connected to the speakers from a single source you'd have to place dummy resistors in place of the speakers if you're going to use your system.
jrdnhsnbrg 10+ year member
Pimped my grandma's ride
Spade terminals?
whitedragon551 5,000+ posts
Moderator
Ive always just used water proof bullet plugs.
Activity
No one is currently typing a reply...
Similar threads
Drill a hole and use the proper protective split loom and hole grommets to keep the outer speaker jacket from knicks and cuts, give just enough...
- Started by Red Dog
- Wiring, Electrical & Installation
Use L+ and -R for sub duty.
- Started by MAHubbard1
- Wiring, Electrical & Installation
So u know the individual slots on the ISO connectors and where they go? 12 volt red is accessories. etc. Red wire goes to the amplifier...
- Started by AnthonyO
- Wiring, Electrical & Installation
Ppl love their Cruze
Often it’s increasing the turbo size, changing the suspension from stock being fe1-3 to fe5, sway bar and links then brakes...
- Started by BudyJames77
- Wiring, Electrical & Installation
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 10
- Views
- 1,153
- Last reply date
- Last reply from
- whitedragon551
Latest topics
-
-
-
Help With Kenwood DDX9907XR / DMX907S - Kenwood Technical Support Can't Help
- Started by fadetoblack73
- Replies: 5
-
-
