No issue with using the top and side posts, I do it all the time...
No idea on what fittings you need, don't run xs batts.
No idea on what fittings you need, don't run xs batts.
I'm pretty sure the top posts are just as good as the side. I think what your wanting to do is okay
Activity
No one is currently typing a reply...
Similar threads
I think you will be just fine to be honest. Id run it and check it after hammering on it quite a bit and check the temp on the wire by hand to see...
- Started by AnthonyO
- General Car Audio
So u know the individual slots on the ISO connectors and where they go? 12 volt red is accessories. etc. Red wire goes to the amplifier...
- Started by AnthonyO
- Wiring, Electrical & Installation
If you do use speaker baffles.. I recommend the plastic ones rather than the foam ones, and drill a 1/4" hole at the bottom of it in the back for...
- Started by JohnPD
- Amplifiers
Some at DIYMA and other places have tried this Oscilloscope as well and got good results shockingly for such a cheap unit...
- Started by bbaker1210
- Wiring, Electrical & Installation
About this thread
Latest topics
-
Jeep center console sub install issues.
- Started by vlusardi
- Replies: 1
-
-
-
-
Help With Kenwood DDX9907XR / DMX907S - Kenwood Technical Support Can't Help
- Started by fadetoblack73
- Replies: 5