Last edited by a moderator:
Wire and fuse holders! KNU 1/0, KNU 4 gauge/ distro block
- Thread starter stangman67
- Start date
- Replies 7
- Views 750
-
3Participant count
-
Participant list
Bettr n' Revrse 5,000+ posts
I do what I want
How much for just the black 1/0?
- Thread Starter
- #3
30 shipped, i'd really like to keep it all together though. Pretty **** good deal with it all together. this is over 150$ worth of wire/accessories.
Hell I will throw in a red stinger volt meter as well.
Hell I will throw in a red stinger volt meter as well.
Bettr n' Revrse 5,000+ posts
I do what I want
Is the 4 gauge OFC?
- Thread Starter
- #6
I'm not going to cut the 1/0 run
---------- Post added at 06:33 PM ---------- Previous post was at 06:33 PM ----------
---------- Post added at 06:33 PM ---------- Previous post was at 06:33 PM ----------
Sure is!
Bettr n' Revrse 5,000+ posts
I do what I want
Thank you sir...
Activity
No one is currently typing a reply...
Similar threads
Use this for the PB bypass.
- Started by HandsomeSteve
- General Car Audio
Sweet!!!!!
- Started by ikpthegame
- Wiring, Electrical & Installation 2
Drill a hole and use the proper protective split loom and hole grommets to keep the outer speaker jacket from knicks and cuts, give just enough...
- Started by Red Dog
- Wiring, Electrical & Installation
It mostly comes down to weight. You can have a super lightweight cone, soft suspension and aluminum coil on a sub and you pretty much get a pro...
- Started by MrButtersworth
- Subwoofers
Yes . Until i get a 3.5 or 4 inch mid
- Started by Bass so loud it HZ
- General Car Audio
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 7
- Views
- 750
- Last reply date
- Last reply from
- Bettr n' Revrse
