8.5"
I'm 100% positive it's 8 3/8".
I just measured //content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif
flange's are 3/8" on each side, overall width is a 32nd short of 9.25", leaving a 32nd under 8.5"
tommyk90 5,000+ posts
THE WHOLE THING!!!
1/16 of an inch leaves that much wiggle room?
Maybe your cuts ****. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif
- Thread Starter
- #8
Cuts were done with a jasper jig so thats not it, maybe I'm just being picky //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif
Since the ports don't have much of a lip for mounting its nice to have them snug on the inside collar of the port too. Will probably put a wrap or two of duct tape on the collar of the port to snug it up, ghetto but should take up the little slack there is.
anj46907 10+ year member
No Longer Truckin
8 3/8" is the perfect size. They fit nice and tight.
If you got a jasper jig why dont you flush mount them, and use hot glue on the inside to keep them in place.
Activity
No one is currently typing a reply...
Similar threads
I don't think this is ideal, but let's assume you can easily mount all the tweeters. That installing them is going to be really simple, and...
- Started by murda Val Boat
- General Car Audio
In this Bidenconomy it is worth around $13,634.
And a loaf of bread.
- Started by spokey9
- General Car Audio
I think your front stage is spot on. If your DSP has a dongle that connects to your phone, then you are getting the full clear signal. No need to...
- Started by Law luck 1
- Subwoofers 2
You could run that sub on a 4 channel amp and have 2 channels left for amping front speakers. I just put a small system in my brothers car with a...
- Started by Swole
- Wiring, Electrical & Installation 2
About this thread
