Jump to content

Sign in to follow this  
ENDER_XVICM

Blown driver

Recommended Posts

I recently blew both of my 6.5" drivers and cant figure out why.

I was driving along and they were acting normal. The sub went off and a second or two later the 6.5" speakers started clipping. Clipping real bad (square sine wave). My friend and I cant figure out what caused it. We have one theory but it isnt at all a strong one. Our thought is this. The sub went off because the gnd and power connection came lose and fell off when I took a sharp turn. They contacted and caused it all. That should have blown my fuses in the power wire though if anything.

Any other thoughts?

 

Here is the setup:

 

Speakers: SLC 365

Amp: JBL CS60.4 (60x4@4ohm / 140x2@4ohm) bridged. Gains are at 4V

Head unit: Not sure on model, lower end pioneer 4V RCA outs volume at 25

 

Sub: older kenwood 300W RMS

Sub amp: older kenwood 600@ RMS Gain at 3V

 

When we checked the JBL amp there was one blown fuse on it.

The amp still works fine so do the X-overs 4" drivers and tweeters

The sub is fine and the sub amp is fine?

 

After typing this out and reading it I also think the 6.5s might have ad a manufacturing defect?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

×