JL vs Morel vs Tangband

Hey, i am going active, and i am pretty set on the mids that i am going to use:

http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=295-335&scqty=2

I have read good reviews on them, and they are apparently very good even compared to the reference series, except they are 8 ohm. They begin to break up around 2k.

I am trying to decide on tweets.

I have a pair of JL XR tweets, but my concern are that they are aluminum, and they have a high crossover point --4000hz.

Other two that i am looking at are:

1) Low end morels:

http://www.partsexpress.com/pe/showdetl.cfm?&Partnumber=277-060

2)higher end tang band:

http://www.partsexpress.com/pe/showdetl.cfm?&Partnumber=264-822

both of these tweets have a much lower FS and xover point. Both can be crossed over at around 2k, and both are silk, which i think is more that i am looking for. I just know that JL is the big name and that is what people like, so i wanted some opinions. I could probably sell the JL's if i didn't use them.

The crossover i will be using is a DHD ntx-6211

http://www.dhdusa.com/f_cross.html