-
7Participant count
-
Participant list
funkyab
ravendarat 10+ year member
CarAudio.com Elite
measure the outside of the bend, then measure the inside of the bend and take the mean average, then figure it out like a strait pipe but use the mean average as the length. So for example if the outside of the bend is 6 inches and the inside is 3 inches then figure the length of the pipe to be 4.5 inches and calculate from there
helotaxi 5,000+ posts
Kilroy was Here
You could figre an average or you could measure one side of the inside of the bend and add that to one side of the outside ofthe bend and multiply by the area of the round cross section. It should be within a ci or two of the volume of the lengh of pipe that it accounts for for port length.
squeak12 10+ year member
CarAudio.com Veteran
Id just calculate it as a continuous length the same as I would PVC. It wont make much a of a difference.
xluben 10+ year member
CarAudio.com Veteran
just take the double integral of the funtion f(x,y)=1 with the proper bounds type I or type II (and convert to polar coordinates to make the integration easier).
at least that's what i'm going to take a quiz on in about 10 minutes, and it actually applies to this situation //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif
at least that's what i'm going to take a quiz on in about 10 minutes, and it actually applies to this situation //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif
just measure down the middle
Bolognablake 10+ year member
Redefining body roll
That's what I always do.
Activity
No one is currently typing a reply...
Similar threads
I’ll try to give them a call I appreciate yall
- Started by jeremy2001
- Enclosure Design & Construction
what ^ said.
amp gain setting info, test tones are at the very bottom...
- Started by Paris Clark
- General Car Audio
Factory. 2021 Chevy Silverado custom trailboss
- Started by filly4thirteen
- Subwoofers
While that program is pretty neat, it assumes you know the values. I was just recapping the numbers you provided. RS recommends the following...
- Started by JuiceTin
- Enclosure Design & Construction
Yes, the power wires' colors don't match from the dash to the new harness. However, I tested them and the wire I'm treating as the constant 12v is...
- Started by muchmany
- Wiring, Electrical & Installation
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 8
- Views
- 7,984
- Last reply date
- Last reply from
- Bolognablake
Latest topics
-
-
Help With Kenwood DDX9907XR / DMX907S - Kenwood Technical Support Can't Help
- Started by fadetoblack73
- Replies: 5
-
-
-
