T1500-1bd + 2re se 12s(older models)

[fatt_macc_2k4 10+ year member]

Ok recently blew my leads when I hooked these two up. Since then I dne had em resoltered and put em in a ported box. Now my question is how much power do I need to send to each one without blowing the leads again. What should I set the amp too ?

Click to read more...

 

[Ksan 10+ year member]

That Amp is WAY to much for those. They are rated at 300RMS Per Sub. You need to get a Voltometer, set the amp to 39.1, wire the subs up to 4Ohm (if they are dual 4) and watch the volume knob. If the subs are not dual 4ohm, well, your going to blow them.

Edit... Seems I was thinking of the SR which is 300Rms. They are right the Se is 600 Rms. We need to know what Ohm they are dual 2 or dual 4. Then we can help you more.

 

[iLL Ridge 10+ year member]

the se's are supposed to take 600rms on d4 configs. How do the 12's sound?

You may have to back off the gain a bit.

 

[miker 5,000+ posts]

SEs are rated at 600rms and can take more no problem.

 

[miker 5,000+ posts]

Also, it would be helpful to know what kind of enclosure the subs are in, what impedance they are wired to and how you have set your amp.