Progect ThunderCat- PICS!!!!

[zane 10+ year member]

Ok, here we go. These are a few pics of my cuurent restoration project before anything was done to the car. I should have pics showing the restore in progress shortly. This page takes a while to load, so please be patient.

http://www.geocities.com/thunderbird302/Cougar.html?1014929961990

take it easy,

-zane

Click to read more...

 

[jrmax 10+ year member]

ewww 302 3:27 gears posi 4 speed that thing will run when you get done but a must for the beast is a mild cam and near factory exhaust I had a truck with a 351 with about 400hp out put and ratty *** exhaust and it was a sleeper. I would rev up to everything in the world they thought they were tough shit until the tire smoke nearly killed them hehe!!!!!!! I am not an audio brainiac but I do no a thing or to about cars!

 

[jester73440 10+ year member]

Hey zane nice project , let me know if you need any rear end parts let me know i can get anything at wholesale prices i think a 8.8 auburn pro posi is like $250 i think thats less then most and gears i can get for like $80

 

[jlman 10+ year member]

Hey man got the same engine in my 95 stang gt i am pretty sure my stock heads would fit on that engine (put on cobra heads on mine) its a H.O. if interested reply back sell em cheap also got a 91 stang 5 speed manul ***** if interested car will run once finished and finished right ROCK ON 5.0.

---------------------------------------------------------------------------------------------------------------------

1 15 inch crystal cmp

jl 500/1 planning to upgrade to 1000.1

fosgate fanatic q componets with fosgate 250.2 powerin them

sony HU cdx 650

ALL RF wirning and capacitor

in a 95 stang GT

 

[zane 10+ year member]

The heads are from a XR7 cougar and have been ported over. So far so good- I will give them a good run once the car is running again and see what happens. I am not too worried about the Current drivetrain, a mild cam has been put into place, as well as 1.7 ratio rockers which allow a little more lift and duration over the stock 1.6 ones. The exauhst is going to be a dual 2.5" model with dual 4" tips and Flowmaster/Edelbrock Mufflers. This will all be custom made.

The current state of the car is allready a far cry from what is shown in the pictures, and has even farther to go to achieve the end result. I have come to the conclusion that I am just too darn picky about this car, so this can be good and bad, either way, I know that it will be done right this way.

take it easy,

-zane

 

[nate2587 10+ year member]

No one can top me, i bumped the oldest thread on here //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

I couldn't help but post this one sorry supa_c but i win //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif 2-28-02 ur was on 10-12-02

 

[02parkave 5,000+ posts]

are you retarded? seriously...