Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
PORT QUESTIONS Truck center console w/ dual opposed 12” NVX 20-25hz
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="066" data-source="post: 8824211" data-attributes="member: 687517"><p>Well I’ve thought on it more and I figured out how to downfire. Now I’m back to port questions lol</p><p></p><p>I’m gonna fire the ports to the rear. If I space them out an inch from the walls and each other, I can put a big flare on each port but the lower 2 will be slightly obstructed with the rear seats down.</p><p></p><p>If I put them all in a line, I can’t put as big of a flare but they can all clear the back seats. I assume this becomes a weak spot though. They would have about 1/4” between each pipe and each end of the board. This is a back panel and will be covered on every side. What if I double up that panel on the inside?</p><p>Or triple/quadruple just that area?</p></blockquote><p></p>
[QUOTE="066, post: 8824211, member: 687517"] Well I’ve thought on it more and I figured out how to downfire. Now I’m back to port questions lol I’m gonna fire the ports to the rear. If I space them out an inch from the walls and each other, I can put a big flare on each port but the lower 2 will be slightly obstructed with the rear seats down. If I put them all in a line, I can’t put as big of a flare but they can all clear the back seats. I assume this becomes a weak spot though. They would have about 1/4” between each pipe and each end of the board. This is a back panel and will be covered on every side. What if I double up that panel on the inside? Or triple/quadruple just that area? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
PORT QUESTIONS Truck center console w/ dual opposed 12” NVX 20-25hz
Top
Menu
Home
Refresh