Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Looking for someone’s help sketching up a 4th order
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Rubn573" data-source="post: 8784816" data-attributes="member: 685612"><p>I have 2 10” deafbonce apocalypse 700watts rms dual voice coil, I have measurements I can work with , I am wanting to do this build 4th order bandpass ported to the center back seat arm rest of a 2005 Nissan Altima . I have measurements inside of truck looking “16.5”height x38”length x (?) max number is 23” the port could fit in an area of 8”width x11”height. The only Perimeters I was given is ;</p><p>Fs33hz</p><p>Qts 0.56</p><p>Bl 18.60</p><p>Vas 27.0</p><p>Xmax 14</p><p>Re 0.8</p><p>Spl 85.2</p><p>I would like the subs facing each other with the port”slot” ported in the front I just don’t know how to get these sealed chambers sized as well as port . I would greatly appreciate anyone help</p></blockquote><p></p>
[QUOTE="Rubn573, post: 8784816, member: 685612"] I have 2 10” deafbonce apocalypse 700watts rms dual voice coil, I have measurements I can work with , I am wanting to do this build 4th order bandpass ported to the center back seat arm rest of a 2005 Nissan Altima . I have measurements inside of truck looking “16.5”height x38”length x (?) max number is 23” the port could fit in an area of 8”width x11”height. The only Perimeters I was given is ; Fs33hz Qts 0.56 Bl 18.60 Vas 27.0 Xmax 14 Re 0.8 Spl 85.2 I would like the subs facing each other with the port”slot” ported in the front I just don’t know how to get these sealed chambers sized as well as port . I would greatly appreciate anyone help [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Looking for someone’s help sketching up a 4th order
Top
Menu
Home
Refresh