Kenwood CD problem

Rockdocta

Junior Member
I recently purchased a Kenwood MP925 CD receiver. After installing it and finally figuring out how to get rid of the demo mode, I find I can't play any CD's. Every CD I load gives an error "TOC error" when it loads. I've probably tried 10 CD's that I know work in my other CD players all with the same results. I am not using a CD changer at this time. Can anyone help me with this? Thank you much!

 
Yes, it says in the manual that the "CD is quite dirty or the CD is not seated in the magazine correctly". I don't have a changer, so I don't think the magazine issue applies to me. And like I said, I tried with 10 CD's or so, all with the same error - so I don't think that it is that they are dirty.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I have 2 more questions about the Kenwood DDX9907XR / DMX907S radios. 1. If I am listening to a source and have that particular source displayed...
0
696
Honestly I don't think it would be hard for them to make it where you use android auto AND your own music source. They made it able to do so...
5
899
@Deiimos Hit it on the spot from the beginning of a bad ground. Excellent! Im happy to hear that you went through some procedures to locate the...
20
2K
I got it to work, I was plugging in the subwoofer while the amp had power. I unhooked the remote turn on lead, then all speakers plugged in, then...
4
1K

About this thread

Rockdocta

Junior Member
Thread starter
Rockdocta
Joined
Location
Portland, ME
Start date
Participants
Who Replied
Replies
2
Views
573
Last reply date
Last reply from
Rockdocta
20231205_074421.jpg

spokey9

    Jul 17, 2024
  • 0
  • 0
Screenshot_20240715-132222.png

1aespinoza

    Jul 15, 2024
  • 0
  • 0

New threads

Top