It took about 1.5 minutes to swap out. A single LARGE Phillips head screw and one connection.At least your door switch is only 11 bux. Mine is like 400 bux even tho the car is 20 years old. I bet yours took all of 20 minutes to install too? Sometimes I wish I didn't drive a Volkswagen.
Matt
It took about 1.5 minutes to swap out. A single LARGE Phillips head screw and one connection.
I had to replace one on my G6 GT. Didn't have to remove the glass but I did have to remove the outer door handle. It was not fun.Oh **** off man! I haven't ordered one for the past 4 years for 2 reasons:
1 - it's ******* 400 bux
2 - I have to disassemble my entire inner door, pull the glass out, remove the latch plate AND outer door handle, and then I can Undo the 3 torx bolts(specialist size obviously) and then unplug the connector with 9 freaking wires. But before I can pull it out I have to Undo a small screw on the side(Phillips, lol) and remove a little arm that actuates the lock "indicator" and connects to the inner door handle.
Damnit, I'm just going to 1.8t swap an accord or something.
Matt
Those make a clean connection rather than having to fuss with loose strands. Nice choice! I like them myself3 amplifiers, each getting short runs of CCA 4awg. from Knukonceptz. Got the ferrules and 3:1 heat shrink on.
I need to do something like that myselfWas bored while out and about so I picked up a little cheap storage unit just for car audio crap.
Congrats man! And we understand. Heck, that’s the thing about doing builds for yourself, no timeline!Not that this build isn't going slow enough but it will now go slower. I just accepted a job that will take up a bit more of my time. The good news is, I am now in charge of my own store.
So I posted a question on a live stream yesterday about my Kenwood eXcelons 5v rca outputs going into the Dayton Audio DSP and was told that I would basically have to back the head unit down to match the input voltage of the Dayton DSP. Basically by half the voltage from 5v to 2.5v I think is what the Dayton says it can handle. It was so much easier with the RF 3Sixty.3... I could run the headunit at full tilt and use the twin knob remote to control both the overall volume and the subwoofer. Sadly, I keep buying car stereo components. I am almost at another full install worth of gear... but no second car.... yet
Thanks Mr. Bear. I always like to have 1 car and 1 truck or SUV. When it comes down to it I think this time it will be a 1999-2004 Jeep Grand Cherokee WJ. I have had XJ's and ZJ's and I miss them but this time I want a hair more luxury and more hiding spaces in the cargo area. If I can land a low miles WJ in good condition I will go back to a pair of 12" subs. Beefier than my JBL P1222's. Those subs hit hard but I think I will go a bit more modern. I would love a pair of DD 712 subs. Put my Smart 3 on them and just sit back and enjoy.Congrats on the new job/position. Did you say what you wanted your second vehicle to be?